The Basic Circle Scribe Toolkit £11.95
One System Cuts ALL Designs
No Dies or Templates Needed!!!
Please
scroll down for more information
Components:
Disk Compass
2 Blade Holders: 1 for Paper/thin
Card 1 for deeper cuts
Ruler
Mechanical Pencil
5 Spare Swann-Morton Scalpel Blades
The
Basic Toolkit is now sold as a stand-alone system with:
·
just a “quick start sheet” for use as a
simple circle cutting tool OR
·
the 40-minute Introductory
DVD for just £5.95. This shows how to cut 2 designs from each book. OR
·
choose a book to suit your particular
interests.
OR NOW YOU CAN GO FOR OUR SPECIAL £20 SHOW
OFFER SAVING NEARLY £8:
·
The Basic Toolkit described above PLUS
·
The Intro DVD and
·
TWO books “3D Cut Fold and Tuck Designs”
and “Craft Shapes….”
The
system is designed to work with all our books and accessories. If
you’re still not sure you can ring 0151 289 5681 for guidance.
This is
the most cost-effective cutting system on the market since no dies or templates
are required. Perhaps it’s not quite as
versatile as the computerised systems on the market but the work you produce is
undeniably your creation and not the computer’s. Of course it a little less expensive as well….
Some
Modelers just want to cut circles from a range of materials and they will just
need the cutting system. Picture
framers can add the Bevel attachment and extension piece to get the least
expensive circular bevel mount cutting system on the market.
Materials
the system cuts include: Card, Fabric, leather, various plastics, wood veneers,
paper, parchment, and even metal foils but considerably less than 2mm of
course,
It uses
Standard Swann-Morton Scalpel Blades size 10A – these are available at most
craft shops and some chemists or from this site at £1 for a pack of 5
The Blade Holders and their Studs
The 2 blade holders give you
different cutting depths controlled by the studs under the holders near the
blade. The holder with studs is used on
thin paper when not working near the center pin. The One with no studs allows full penetration of the blade and
cuts through card or mount board up to 2 mm thick
